- Contact：Mr. Song
- Phone：0086-13705113637
- Tell：0086-0515-88809180
- Fax：0086-0515-88809181
- E-mail：jsjckt@126.com
- Address：No. 18, Rongguang Road, National High-tech Park, Yancheng City, Jiangsu Province
Industrial air conditioning is mainly installed in factories and production workshops in all walks of life. It can not only make the temperature of the factory reach a comfortable environment, but also improve air quality, odor, dust and flying hair. In the process of using industrial air conditioning, there will be smaller air volume, no refrigeration, outlet odor and other problems. How should we deal with these problems?
Some customers, from the installation of industrial air conditioning, no cleaning and maintenance. In this case, if the wet curtain and filter screen of industrial environmental protection air conditioning are removed, it will be found that the blockage is more serious, and the filter is almost completely covered by dust. The wet curtains where the water was stored were also covered with dust. After washing with clean water, the filter and wet curtain are restored as new, and the ventilation and cooling effect of industrial environmental protection air conditioning has been greatly improved.
Maintenance methods of industrial air conditioning:
Open the intake grille, holding two button, at the same time slowly down, hold air filter hooks syncline below pull out, remove the filter, the cleaning method: use a vacuum cleaner to remove dust, or clean with clear water or warm water, too much dust with a soft brush to add neutral detergent, wash after dumped water, then dry in the shade. Remember not to use hot water above 50℃ to clean, so as not to fade or deformation; Do not dry on the fire, the filter may catch fire, air filter must be installed after cleaning. The air filter is hung on the protruding part of the upper part of the suction grate, and then fixed on the suction grate; Slide the convex handle on the back of the suction grille inward, install the air filter on the suction grille, and close the suction grille. Contrary to step 1, press the filter signal reset button on the control panel, and the reminder sign of central air conditioning cleaning will disappear. If the use of environmental dust is too much, the air filter should be cleaned about half a year once.
The common physical cleaning method of industrial air conditioning is the main engine through the gun, that is, through the compressed air or manual punching rod, rubber plug, nylon brush or round steel and other tools through the heat exchanger tube, to remove the accumulation or infarction in the tube. Open the end cover of the main engine, use the gun to pass through the copper pipe one by one, clean the biological mud and rust slag of the pipe wall, and rinse with high-pressure water at the end of the gun. Then all the rust slag and scale blocks on the side of the water chamber and the inner wall of the end cover are completely eradicated, and the anti-rust paint is brushed twice to play the role of rust removal, rust prevention, scale removal and scale prevention.
Industrial air conditioning, chemical fiber industrial air conditioning, chemical fiber industry refrigeration, textile industrial air conditioning, dust-free workshop cooling, ventilation pipeline, cooling tower, freezer and other air conditioning units and accessories.
Jiangsu Jincheng Air Conditioning Engineering Co., Ltd. is a comprehensive manufacturer of special air-conditioning equipment design, production, installation, and commissioning of clean room, electricity, tobacco, civil air defense engineering, medical clean room, clean room, electricity, tobacco, civil air defense engineering, medical clean room. Mainly produce JCZK combined air conditioning unit, cooling tower, glass steel ventilated galvanized sheet pipe, stainless steel pipe, polyurethane ventilation pipe and air conditioning accessories, Jincheng air conditioner is wide, the type, the unique model, superior performance, and user Favused.
